Taring Off Additional Weight (Tare); Keeping The Measured Result In The  Display (Hold) - Seca 336 Mode D'emploi Et Garantie

Taring off additional weight (Tare)

Keeping the measured result in the
All the elements of the display are shown briefly, then
display.
The scale is operational when
If the scale is operated with a power supply unit, the
the display.
If a digital measuring rod is connected to the scale, the measuring rod is
switched on automatically (see "Measuring with the digital measuring rod"
from page 59).
3. Place the baby on the scale.
4. Press the
The weight value is displayed permanently. The
function) and the "HOLD" message are displayed.
5. Read off the measured result.
Using the TARE function, you can prevent any additional weight (e.g. a towel
or a cushioned mat on the weighing surface) from affecting the weighing
result.
1. Place the additional weight on the scale.
2. Hold down the
display.
3. Wait until the display stops flashing and
4. Place the baby on the scale.
5. Read off the measured result.
The additional weight is deducted automatically.
6. To deactivate the TARE function, press the
message is no longer displayed or switch off the scale.
When you activate the HOLD function, the weight value continues to be dis-
display (Hold) played after the load is removed from the scale. This allows you to take care
of the baby before recording his or her weight.
1. Place the baby on the scale.
2. Press the
The display flashes until a stable weight is measured. The weight is then
continuously displayed. The
"HOLD" message are displayed.
3. To deactivate the HOLD function, press the
NOTE
When the Autohold function is activated, the weight value is automati-
cally displayed permanently (see "Activating the Autohold (AHOLd)
function" on page 62).
arrow key briefly.
hold
NOTICE!
Incorrect measurement as a result of force shunt
If an additional weight, e.g. a large towel, contacts the surface on
which the scale is placed, weight will not be measured correctly.
►
Make sure that additional weights are only placed on the scale's
weighing surface.
arrow key until the "NET" message appears in the
tare
NOTE
The maximum weight which can be displayed is reduced by the
weight of the objects already placed on the scale.
NOTE
When the Autohold function is activated, the weight value is automati-
cally displayed permanently (see "Activating the Autohold (AHOLd)
function" on page 62).
arrow key briefly.
hold
seca
appears in the display.
0.000
symbol appears in
symbol (non-verifiable
appears instead.
0.000
arrow key until the "NET"
tare
symbol (non-verifiable function) and the
arrow key briefly.
hold
English
appears in the
Operation • 57