Measuring With The Analog Measuring Rod; Measuring With The Digital Measuring Rod; Measuring With Barcode Detection (336 I) - Seca 336 Mode D'emploi Et Garantie

Measuring with the analog
Measuring with the digital

5.3 Measuring with barcode detection (336 i)

You can determine length using the
obtainable as an option.
measuring rod
1. Place the baby on the scale so that his or her head is in contact with the
2. Pick up the measuring rod by the handle.
3. Slide the foot stop up to the baby's feet.
4. Read off the measured result.
You can determine length using the
measuring rod option and transmit this to the scale.
If your scale is equipped with a WiFi interface, you can send length and
weight to an HIS or to seca software.
1. Place the baby on the scale so that his or her head is in contact with the
2. Pick up the measuring rod by the handle of the foot stop.
3. Slide the foot stop up to the baby's feet.
4. The measured value is shown in the display of the measuring rod.
5. Press the
6. In order to transmit measured values to an HIS or to seca software,
The WiFi interface of the device connects the scale wirelessly to an HIS or to
seca software.
With a barcode scanner, you can record the IDs of the baby and the user.
The patient data for the baby are called up from the HIS and linked to the
measured results. The measured results are then transmitted wirelessly to the
HIS or to seca software.
The following conditions must be met in order to be able to identify both user
and baby by means of barcodes:
head stop of the measuring rod.
NOTE
Ensure that the baby's legs are stretched out straight.
NOTICE!
Data loss
Analog measured values cannot be entered into the device.
►
Enter analog measured values directly in the patient file to prevent
data loss or the incorrect assignment of measured results.
head stop of the measuring rod.
NOTE
Ensure that the baby's legs are stretched out straight.
key on the measuring rod.
hold
The measured value for length is transmitted to the scale.
proceed as described in the section entitled "Measuring with barcode
detection (336 i)" from page 59.
• WiFi interface of the device is active
• Device is connected to an HIS
• Barcode scanner is connected to the device
NOTE
Observe the maximum permitted current consumption of the barcode
scanner (see "General technical data" from page 70). You can find a
list of recommended scanners at www.seca.com.
analog measuring rod
seca 232 n
measuring rod available as an
seca 234
Operation • 59
English