PRO-POINT 208CC OHV Manuel De L'utilisateur page 22

8628257 208CC OHV GAS ENGINE WITH ELECTRIC START
4. Check the gap with a spark plug gauge as shown in Figure 7.
If necessary, reset the gap (See Specifications).
4.1 Correct the gap by
carefully bending the
side electrode. Check
the gap after each
adjustment.
5. Install the spark plug
carefully by hand to avoid
cross threading.
6. Tighten the spark plug to the
recommended torque until
the gasket is compressed.
See Specifications for the
correct torque rating.
6.1 Tighten an additional 1/2 to 1/3 turn more with a spark
plug wrench if the torque rating isn't available.
7. Reconnect the spark plug lead to the spark plug.
ADJUSTING THE ENGINE IDLE SETTING
NOTICE! The engine speed is set by the factory. Increasing
the speed too much can damage the engine. Too low a speed
will reduce the engine's efficiency. Have a qualified technician
adjust the engine speed if necessary.
The engine's idling speed is adjustable by
turning the idle screw to lower or
increase the engine output (RPMs).
1. Start the engine and wait for it to idle.
2. The idle screw is above the fuel
sediment cup (Fig. 8-1). Tighten the
screw to increase the engine speed.
Loosen to reduce speed. The standard
idle speed is 1,800 ± 150 RPM.
22 For technical questions call 1-800-665-8685
V 1.0
Fig. 7
Fig. 8