Carburetor Adjustment - PRO-POINT 208CC OHV Manuel De L'utilisateur

V 1.0 208CC OHV GAS ENGINE WITH ELECTRIC START
3. Pour oil into the funnel. Allow the oil to settle for one
minute and recheck the level. Repeat until the desired level
is reached.
4. Insert the oil filler cap and hand tighten.
5. Wipe up any spilled oil. Dispose of oil soaked rags in a proper
hazardous waste container.
HOW TO DRAIN OIL
WARNING! Do not tip the engine while draining. This can cause
fuel to leak into the oil compartment, creating a potential fire
hazard. If this is unavoidable, drain the fuel from the engine
before draining the oil.
1. Remove the dipstick (L).
2. Place an approved container
below the oil drain plug
(Fig. 5).
3. Remove the oil drain plug
and allow oil to the drain into
the approved container.
4. Install oil drain plug and
tighten with a wrench.
IMPORTANT! Used oil must be
disposed of properly. Do not pour it on the ground, down a
drain or throw it in the trash. Take the oil to your local recycling
centre or a service station for reclamation.

CARBURETOR ADJUSTMENT

Never make adjustments to the carburetor. The carburetor was
set at the factory to operate efficiently under most conditions.
Only a qualified service technician should adjust the carburetor if
it is required.
Visit www.princessauto.com for more information
8628257
Fig. 5
17