Fitting The Feet - SIFA QUAD Mode D'emploi

GB
You should also make sure, during installation (Fig.
6), that:
- There is sufficient air circulation around the display
unit but not so much as to constitute a draught.
- The display unit is not placed near sources of hot
air.
- It is not exposed to direct sunlight.
- The grilles designed to let air pass through for the
cooling of the condenser are not blocked.
- Any air conditioning or heating inside the premises
is not directed at the display unit.
NOTE:
All malfunctions caused by failure to
observe the above instructions shall not
be covered by the warranty.

2.5 FITTING THE FEET

CAUTION - RISK OF CRUSHING!
This operation requires two or three people.
1- Lift the display unit using a suitable device (pallet stacker, etc...) (Fig. 7a).
2 - Place the cardboard boxes or similar items underneath the side panels (Fig. 7a, pos. A) in order to
prevent damage from occurring.
3 - While the display unit is lifted, loosen the feet using a suitable wrench (Fig. 7b, pos. B) and remove
the runners (Fig. 7b, pos. C).
4 - Screw in the feet (Fig. 7c, pos. D).
Fig. 7-a
5 - Bring the display unit back to a standing position
on the floor.
6 - Adjust the feet (Fig. 7c, pos. D) so that the display
unit is level and at the correct height (Fig. 7d).
7 - If the display units must be ducted, wait until they
have been assembled first.
Fig. 7b
A
Fig. 7-d
39
C
B
Fig.6
Fig. 7c
D