Setting Of Car Address; Maintenance And Care; Important Information; Troubleshooting Driving Tips - Carrera DIGITAL 124 Instructions De Montage Et D'utilisation

Setting of car address

1 2
2
3 4
3 2
While the car address is displayed, in addition a dot will turn up in
the segment display bottom right, fig. . Switch on the Control Unit,
1
6 7
fig. ; the up-to-date car address 3 will be indicated for approx.
2
3 seconds. By pushing the control button
be changed to another address. Push the button
till the desired address 3 will be shown. After 3 seconds the seg-
ment display 3 will change to the race position again.

Maintenance and care

1
To ensure a proper operation of the motor-racing circuit, all race-
track components should be regularly cleaned. Pull the plug prior
to cleaning.
Racetrack: Keep the track surface and track slots clean with a
1
dry cloth. Do not use any solvents or chemicals for cleaning. When
it is not in use, store the racetrack in a clean and dust-protected
location, preferably in the original cardboard box.
10

Important information

EVOLUTION
1
8
4 the car address can
4 as many times
Carrera DIGITAL 124/132
Please note that Evolution (analog system) and Carrera
DIGITAL 124/132 (digital system) involve two separate and com-
pletely independent systems. We hereby expressly indicate that
both systems must be kept separate when setting up the track, i.e.
no connecting rail from Evolution may be used together with the con-
necting rail and Black Box of the Carrera DIGITAL 124/132, even if only
one of the two connecting rails (Evolution connecting rail or Car-
rera DIGITAL 124/132 connecting rail and Black Box) is attached to
the current supply. Furthermore, no other Carrera DIGITAL 124/132
components (switches, electronic lap counter, pit stop) may be built
into an Evolution course, i.e. via analog operation.
Non-compliance with the above information may result in damage or
destruction of the respective Carrera DIGITAL 124/132 components.
In this case no warranty may be claimed.
Carrera DIGITAL 124/132
EVOLUTION
Troubleshooting
Driving tips
Troubleshooting:
In case of any malfunctions, please check the following:
• Has the connection to the power supply been established cor-
rectly?
• Have transformer and speed controllers been connected
correctly?
• Are the track connections faultless?
• Are the racetrack and track slots clean and free of any foreign
objects?
• Are the sliding contacts in order and do they make contact with
the track slot?
• Are the cars correctly coded to the according speed controller?
• The track's current feed will be switched off automatically for 5
seconds, if there is an electrical short circuit: this will be notified by
audible and visual signals.
• Are the cars placed on the track in running direction? In case of
non-functioning push the running direction switch which is on the
car´s bottom.
Note:
During operation small car parts as spoilers or mirrors may get off or
brake due to being original detailed parts of the car model. To avoid
this it is possible to remove them before operation.
Driving technique:
• You can drive fast along the straight track but you should brake
before the curve and then accelerate again when coming out of the
curve.
• Do not fasten or block the vehicles when the motor is running:
overheating or damage to the motor could result otherwise.
Note: When using track systems which are not manufactured by
Carrera the existing guide keel has to be replaced by the spe-
cial guide keel (#20085309). While using the Carrera crossing
(#20020587) or high banked curve 1/30° (#20020574) slight driving
noise might occur which is due to the full-scale genuineness and
does not affect flawless operation.