Using The Fan; Switching The Fan On And Off; Automatic Function - Atag HIDD8471E Instructions D'utilisation Et De Montage

Cover
Fan Indication
Press for a longer time
44
Operation

4.25 Using the fan

The fan is located in the middle of the hob with the extractor
facing downwards.
IMPORTANT
Risk of burning!
Do not put the cover onto the induction hob!
4.25.1 Switching the fan on and off
1. Press the ON/OFF key
power setting 0 appears and a short signal will sound.
The controls are ready for operation.
2. Use the power setting display (as a key) to select a
cooking zone. The standby dot will light up.
3. The touch control
immediately afterwards. A power setting will be switched
on.
........ left ..........setting 0
........ center .....setting 5
........ right ........setting P
To change the fan level, select the fan display and then
press the sensor fi eld.
Important: the stand-by dot of the cooking zone selected
must light up.

Automatic function

1. To select the automatic mode, press the fan display
(as key) until an A for automatic mode is shown in the
display. The standby dot will light up.
2. Then select one or more cooking zones and set a power
level.
3. The fan level is now automatically controlled according to
the set power levels.
The automatic mode regulates slightly delayed and gradually
according to the set power levels.
You can switch back to manual mode at any time by holding
down the fan display or selecting the fan display and
pressing the sensor fi eld.
NOTE
In order to ensure that extraction functions well with tall
cooking pots (e.g. pots used for cooking asparagus),
you can place a wooden spoon under the lid of the pot.
(approx. 1 sec.) until the Fan
must be activated
GB