Operating The Hob With The Sensor Keys; Worth Knowing About The Slider (Sensorfi Eld) - Atag HIDD8471E Instructions D'utilisation Et De Montage

Masquer les pouces Voir aussi pour HIDD8471E:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.1 Operating the hob with the sensor keys

The glass ceramic hob is operated with touch control
sensor keys. The sensor keys are operated as follows:
lightly touch a symbol on the surface of the ceramic glass
plate. A buzzer will indicate when the controls have been
operated correctly.
The touch control sensor key will then be indicated as
"key".
Permanent pan recognition
If the hob has permanent pan recognition, a cooking
setting can only be directly switched on via the sensor
fi eld after a pan has been detected on the hob and the
power display shows 0.
ON/OFF key
(8) Cooking zones left or right
This key is used to switch the entire hob and the fan on
and off .
Power boost in the sensor fi eld
The power boost setting makes additional power
available for induction cooking zones.
Stop key
(10)
The STOP function can be used to briefl y stop the
cooking process.
Recall function
(10) (recovery function)
The most recent setting can be recovered if the hob is
switched off unintentionally.
Lock key
(11)
The lock key can be used to lock all of the keys.
Keep warm key
(12)
To keep warm
Minus key
/Plus key
These keys are used to set the timer and the automatic
switch-off function of the cooking zones as well as the
automatic delay stop of the fan.
Symbols
.................. Timer function, automatic switch-off device
Power setting display
The power setting indicator shows the power setting
which has been selected, or:
.................. Residual heat
.................. Power boost
.................. Pan recognition
.................. Automatic boost function
.................. Stop function
................... Childproof lock
................... Keeping warm
Fan indicator (17)
The power setting indicator shows the power setting
which has been selected, or:
..............Automatic function
..............Replacing the carbon fi lter
Appliance description
(13)
(16)
3.2 Worth knowing about the slider (sensorfi eld)
In principle, the slider functions the same as the touch
controls; the only diff erence is that you can put your
fi nger on the glass ceramic surface and then move it
around. The sensor fi eld recognises this movement
and raises or lowers the display setting (power level) in
accordance with the movement.
The term sensor fi eld is used to mean slider from now on.
Sensor fi eld
What must be observed when operating sensor
fi elds?
Your fi nger should not be placed fl at onto the glass
ceramic surface in order to avoid adjacent keys/sensor
fi elds from reacting by mistake.
unsuitable
Press the sensor fi eld lightly or move your fi nger
around
You can press the sensor fi eld very lightly with your
fi nger; when this is done the setting on the display (power
level) will gradually change.
When you put your fi nger on the sensor fi eld and then
move it to the left or right, the display setting will change
progressively.
The faster the movement , the faster the change in the
display .
touch
GB
right
move
35

Publicité

Table des Matières
loading

Table des Matières