Extraction - Atag HIDD8471E Instructions D'utilisation Et De Montage

5.2 Extraction

Cleaning the grease fi lters
Clean the grease fi lter in the dishwasher or in mild soapy
water at least once a month or in the event of excessive
grease deposits and/or intensive use.
Lift the extraction hood before removing the fi lter. This
makes it easy to remove the fi lter for cleaning.
The fi lter can be rinsed in a dishwasher. Turning the
NOTE
Do not place the glass cover too fi rmly. Risk of glass
breakage.
fi lters in the dishwasher upside down. Please use only
rinse aid that is suitable for RVS use with aluminium in
order to avoid damaging and discolouring the fi lters.
Never rinse right next to glasses or light-coloured
porcelain.
Do not operate the extractor without grease fi lters!
After rinsing the fi lter, dry it and replace it in the extractor.
Please make sure that the recessed handle is visible
after you have replaced the fi lter. If possible, wipe the
easily accessible inside of the extractor with a cloth
dampened with detergent every time you replace a fi lter,
while at the same time paying attention to protruding
parts in the inside of the extractor.
Cleaning and care
Extractor cleaning and care
The extraction housing is best cleaned every time you
clean the fi lters.
Condensation water may collect under the extraction
housing after water has boiled rapidly with the lid of the
pot removed. This is quite normal. The water should,
however, be removed and the inside of the extraction
housing cleaned.
Failure to clean the grease fi lter and the housing in
good time can lead to unpleasant odours at rest and at
the beginning of the extraction process. It is therefore
advisable to carry out this cleaning at least once a month.
It is best to clean the housing with a damp, soft cloth and
mild detergent solution.
Service
The recirculating air fi lter must remain accessible. If
an activated carbon fi lter is used, clean or replace the
Glass cover
carbon fi lter mats as indicated with
Removable Floor
The fl oor can be removed for cleaning.
Switch off the hob and fan and remove the glass cover
and the fi lter.
Hold the bottom fi rmly with one hand from below and
open the 4 locks with the other hand. After opening,
hold the bottom horizontally and carefully remove it
downwards.
Drain any liquids and thoroughly remove any impurities.
Clean the accessible inside of the housing. Optionally,
the bottom can be cleaned in the dishwasher.
It must be reset in place after cleaning and attached with
the 4 closures.
GB
.
47