Using Bluetooth; Pairing Bluetooth With Your Mobile Phone; Playing Music From Your Mobile Phone; Display Modes - PERFECTPRO ROCKBULL Mode D'emploi

USING BLUETOOTH

Pairing Bluetooth with your mobile phone

1. Press the ON/OFF button to turn on the radio.
2. Select Bluetooth mode by pressing the SOURCE button.
3. The LCD display will show a flashing Bluetooth indicator in the bottom side of the
display when radio is not yet paired with your mobile phone.
4. In your mobile phone open the Setting menu and select Bluetooth, then select
"RockBull" in the Bluetooth devices list (Bluetooth pairing instructions may vary
per type of mobile phone, please check your mobile phone manual).
5. When Bluetooth pairing is successful, the Bluetooth indicator will be lit, and the last
played music information of the mobile device will be displayed.

Playing music from your mobile phone

1. Press the ON/OFF button to turn on the radio.
2. Select Bluetooth mode by pressing the SOURCE button.
3. Start playing music by using the media players in the paired mobile phone.
4. Playback can be controlled from the mobile phone or by pressing the numeric
button "3", "4" or "5" on the radio.
5. After music playback started, the name of the song will be displayed in the LCD.

Display modes

In Bluetooth mode, the radio can display a range of information of the current playing
music on the display. Press the INFO button to cycle through the various types.
a. Artist Displays the artist's name of the current playback music.
b. Album Displays the album name of current playback music.

Device List

In the radio, you can select the Bluetooth device from the device list to connect again.
The device names would be shown if the name of the Bluetooth devices were configured
in the mobile devices. Please refer to the user manual of your mobile device for the
configurations.
The device lists can be checked as below:
1. In Bluetooth mode, press the MENU button.
2. Rotate the TUNING control to "View details"; press the TUNING control to select
setting.
3. Rotate the TUNING control to "Paired Device list"; press the TUNING control to
select the setting.
4. Rotate the TUNING control to view the name of the devices.
5. Press the TUNING control to start Bluetooth reconnection. The speaker will
automatically connect to this mobile device.
13
Note: There can be up to 8 device names to be stored in the speaker. If there are more
than 8 mobile devices have been connected and stored into the speakers, the earliest
paired device name will be erased.
Note: If you have ever deleted the "RockBull" from your connected mobile device, the
auto reconnection will be unsuccessful.

Restart Bluetooth pairing

The Bluetooth function can be set to operate in different ways as below:
1. In Bluetooth mode, press the MENU button.
2. Rotate the TUNING control to "Setup Bluetooth" options, and press the TUNING
control to select the setting.
3. The radio will try to disconnect the current paired Bluetooth, then available to be
connected by the new Bluetooth device.
4. At the stage, the Bluetooth indicator will be flashing on the screen until the new
Bluetooth pairing is completed.
Note: "Setup Bluetooth" is the option that force the Bluetooth of this radio to disconnect
from your mobile phone and enter the "discoverable mode". This is the way to allow
the Bluetooth pairing to another device. If no new device is paired, the Bluetooth will
automatically try to connect to the last device when it is switched off and on again.
The Auto-Power management function will be activated in Bluetooth mode. If there is no
signal from Bluetooth for a period of over 15 minutes, the radio will automatically switch
to standby mode. Pressing the ON/OFF button will wake up the unit.
GB
GB
14