Section 3 − Installation; Required Torch Parts And Torch Assembly; International Style Connector Assembly - Miller Diamondback Série Manuel De L'utilisateur

3-1. Required Torch Parts And Torch Assembly

Assembling Torch Parts
3
2
1
15
1 Cup
2 Collet Body
3 Heat Shield
4 Backcap Insulator
5 Collet
6 O-Ring
7 Backcap
8 Torch Body
9 Handle

3-2. International Style Connector Assembly

1
2
Tools Needed:
OM-1600 Page 4
SECTION 3 − INSTALLATION
7
6
5
4
8
10 One-Piece Power Cable
11 Power Cable Adapter
12 International Style Flow-Through
Adapter
Note: Adapter needed only if torch is
equipped with one-piece cable.
13 Two-Piece Power Cable
14 International Style Connector
3
(26 mm)
13
9
10
Or
11
1 in
5
4
3
14
12
Ref. ST-802 566-B
Note: Connector needed only if torch is
equipped with two-piece cable (see Section
3-2).
Assembling Torch Body
Keep connections tight. Replace cup, heat
shield, and backcap as needed.
15 Tungsten Electrode (See Section 5)
Installing Tungsten
To adjust tungsten position, loosen back-
cap.
1 Weld Output Cable
2 Insulating Boot
3 Sleeve
Slide insulating boot onto cable;
strip cable and install sleeve.
4 Connector Body
5 Setscrew
Insert cable with sleeve fully into
connector body, tighten setscrew,
and slide insulating boot over con-
nector.
ST-156 496