Device Elements; Quick Start Instructions; Start Up; Attaching The Accessories - Kärcher Puzzi 10/1 Manuel D'utilisation

Device elements

Illustration
1 Hand nozzle for upholstery cleaning
(Puzzi 10/1 only)
2 Cable hook
3 Adapter for accessories (homebase)
4 Holder for accessories
5 Power cord

6 Quick start instructions

7 Fresh water tank
8 Fresh water sieve
9 Switch for spraying
10 Switch for vacuuming
11 Casing
12 Nameplate
13 Steering roller
14 Spray hose connection
15 Suction hose connection
16 Container for defoaming agent (Puzzi
10/2 Adv only)
17 Cover
18 Storage compartment for detergent
tabs (Puzzi 10/2 Adv only)
19 Carrying handle of the appliance
20 Floor nozzle for carpet cleaning
21 Carpet adapter
22 Unlocking device of the floor nozzle
23 Suction pipe
24 Nozzle mouth piece
25 Union joint
26 Handle
27 Bender
28 Lever on the manifold
29 Spray hose
30 Suction hose
31 Spray/suction hose
32 Dirt water reservoir, detachable
33 Carrying handle of the wastewater con-
tainer
34 Seal on the lid
35 Fluff filter

Start up

 Check high power cable, extension ca-
bles and hoses for damage every time
before use.

Attaching the Accessories

 Attach the suction pipe to the floor noz-
zle and hand-tighten the union nut on
the floor nozzle.
 If required, slide the handle onto the
suction pipe and hand-tighten it in the
desired position.
 Place the elbow over the suction pipe
and tighten the union joint on the elbow
fingertight.
 Insert the suction hose into the suction
hose connection on the appliance.
Attach the coupling of the spray hose to
the spray hose connection of the appli-
ance and snap in place.
 Connect the suction hose to the elbow.
Connect the coupling of the spray hose
with the manifold and snap in place.
Prepare cleaning solution
WARNING
Health risk, risk of damage. Observe all in-
dications on the detergent used.
 Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
Dissolve detergent in the water.
Note: Warm water (max. 122°F/50°C) will
increase the cleaning effect. Verify the tem-
perature resistance of the surface to be
cleaned.
Note: For considerate treatment of the en-
vironment use detergent economically.
Fill up fresh water reservoir
 Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
Defoaming agent
Note: When cleaning previously sham-
pooed carpets, foam is generated in the
wastewater container. This formation of
foam can be prevented by adding a de-
foaming agent.
Puzzi 10/1 only:
 Put defoaming agent (optional accesso-
ry) into the wastewater container.
– 2
EN 7