Operation - Kärcher Puzzi 10/1 Manuel D'utilisation

Puzzi 10/2 Adv only:
 Open container for defoaming agent.
 Fill in defoaming agent (optional acces-
sory).
Replacing the carpet adapter
 Push the unlocking device of the floor
nozzle on one side.
 Swivel out and remove the carpet
adapter.
 Insert a new carpet adapter and snap
the locking device in place.

Operation

Turning on the Appliance
 Plug in the mains plug.
 Press the suction switch to turn on the
suction turbine.
 Press the spray switch to switch on the
spray pump.
ATTENTION
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
 Operate the lever on the manifold in or-
der to spray the cleaning solution.
 Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
 In case of work interruptions, the floor
nozzle can be stored in the carrying
handle of the device.
Turn off the appliance
 Switch off the spray and suction switch-
es.
 Pull out the mains plug.
Empty wastewater container
 If the dirt water reservoir is full, switch
off the suction and spray switches.
 Remove the lid.
 Remove the wastewater container from
the appliance and drain it.
8
Cleaning
Empty the fresh water reservoir
 Turn off the appliance.
 Shortly activate the lever on bender to
decrease the pressure.
 Separate bender from the spray/suction
hose.
 Insert the suction hose into the fresh
water reservoir.
 Press the suction switch to turn on the
suction turbine.
 Empty the fresh water reservoir and
switch the appliance off.
 Remove the lid.
 Remove the wastewater container from
the appliance and drain it.
Flush appliance
 Connect the manifold (with suction pipe
and nozzle) to the suction hose.
 Connect the coupling of the spray hose
with the manifold and snap in place.
 Fill approx. 0.5 gal (2 litres) of fresh wa-
ter into the fresh water reservoir.
Do not add any detergents.
 Press the spray switch to switch on the
spray pump.
 Hold floor nozzle over a drain.
 Activate lever on bender and flush the
appliance for appr. 1 to 2 minutes.
 Turn off the appliance.
After each operation
 Flush appliance.
 Empty the wastewater container and
clean it under running water.
 Empty the fresh water reservoir.
 Clean the outside of the appliance with
a damp cloth.
 Remove all water from the appliance
prior to longer periods of non-use to
avoid offensive odours.
 Allow appliance to dry thoroughly: Re-
move or move lid sideways.
Storing the Appliance
 Place the appliance in a dry room and
secure it from unauthorized use.
– 3
EN