Storch ProDist smart Mode D'emploi page 115

define the values (first a, then b). After entering the
desired value, confirm by pressing the button.
Follow the same steps for the „b value", again con-
firming by pressing the button.
Now initiate the measurement by pressing the
button. The laser measuring device measures in
permanent measuring mode.
The display shows the current measuring distance
in the lower main line. Move the laser measu-
ring device slowly towards the line you want to
marl. The laser measuring device will show you the
distance to the mark point at regular intervals. The
device beeps as of a distance of 0.1 m from the next
mark point.
The arrows in the display, or show the direc-
tion in which you need to move the laser measu-
ring device to reach the predefined dimension (eit-
her a or b). Once you have reached the mark point,
an audible signal is output, and the intermediate
line flashes. You have now reached the required
distance.
115