Disassembly And Reassembly - Xylem rule Fully Automatic Bilge Manuel D'instructions

Installation:
We recommend using #8 Stainless Steel screws of an adequate length as to secure the pump but not penetrate the entire
thickness of the hull. Use a flexible sealant in the screw holes to prevent water from penetrating the screw holes.
Best practice: Periodically clean the sensor housing with a mild detergent to remove any build-up that may interfere with
the proper operation of the bilge pump. If the sensor accumulates excessive build-up, the pump will enter the timer mode
to protect the pump and the vessels batteries. Once the debris is removed, the pump will return to level sense mode.

Disassembly and reassembly

Screws
5