Cleaning The Sediment Cup; Emission Control System Information - Power Fist 8893521 Manuel De L'utilisateur

V 4.0
increase in altitude. The effect of altitude on engine power will be greater than
this is if no modification is made.
NOTICE! When the carburetor has been modified for high altitude operation, the
air fuel mixture will be too lean for low altitude use. Operation at altitudes
below 5,000 ft (1,524 m) may cause the engine to overheat and result in serious
engine damage. When using this engine at low altitudes, have a qualified
technician return the carburetor to original factory specifications.

CLEANING THE SEDIMENT CUP

CAUTION! Wear latex or rubber gloves when working on the sediment cup.
The cup may contain fuel that will cause skin irritation. Prolonged and
repeated exposure to fuel on skin may result in dry, cracked skin.
1. Switch the fuel valve to the OFF position.
2. Remove the fuel sediment cup, screw and o-ring.
3. Clean the sediment cup with a non-flammable solvent or detergent and
rinse. Allow to dry.
a. Some chemicals will damage the o-ring material. Check for
compatibility or replace the o-ring.
4. Reassemble the sediment cup and o-ring.
5. Switch the fuel valve to the ON position and check for leaks. Replace the
o-ring if the installation is correct, but fuel still leaks from the cup.

EMISSION CONTROL SYSTEM INFORMATION

The combustion process produces carbon monoxide, hydrocarbons and
nitrogen oxides. Controlling these emissions is important for personal and
environmental health.
The following instructions must be followed in order to keep the emissions from
your engine within Canadian emission standards.
1. Do not remove or alter any part of the intake, fuel or exhaust system.
2. Do not alter or bypass the governor linkage or a speed-adjusting
mechanism that force the engine to operate outside its design
specifications.
Visit www.princessauto.com for more information
Engine for the 15 Ton Kinetic Log Splitter 8893521
13