Carburetor Adjustment - Power Fist 8893521 Manuel De L'utilisateur

8893521
3. Pour oil into the funnel. Allow the oil to settle for one minute and recheck
the level. Repeat until the desired level is reached.
4. Insert the oil filler cap and hand tighten.
5. Wipe up any spilled oil. Dispose of oil soaked rags in a proper hazardous
waste container.
HOW TO DRAIN OIL
WARNING! Do not tip the engine while draining. This can cause fuel to leak
into the oil compartment, creating a potential fire hazard. If this is
unavoidable, drain the fuel from the engine before draining the oil.
1. Remove the dipstick (Fig. 4-1).
2. Place an approved container below the oil
drain plug (Fig. 5).
3. Remove the oil drain plug and allow oil to
the drain into the approved container.
4. Install oil drain plug and tighten with a
wrench.
IMPORTANT! Used oil must be disposed of properly. Do not pour it on the
ground, down a drain or throw it in the trash. Take the oil to your local recycling
centre or a service station for reclamation.

CARBURETOR ADJUSTMENT

Never make adjustments to the carburetor. The carburetor was set at the factory
to operate efficiently under most conditions. Only a qualified service technician
should adjust the carburetor if it is required.
MODIFYING THE CARBURETOR FOR HIGH ALTITUDES
At high altitude, the standard air-fuel mixture is too rich, causing increased fuel
consumption and decreased performance. A rich mixture will also foul the spark
plug and cause hard starting.
A qualified technician can improve high altitude performance with certain
modifications. Have your carburetor modified if the engine will routinely be
operated at altitudes above 5,000 ft (1,524 m). Even with carburetor
modification, engine power will decrease about 3.5% for each 1,000 ft (305 m)
12
Engine for the 15 Ton Kinetic Log Splitter
For technical questions call 1-800-665-8685
V4.0
Fig. 5