Fuel Recommendations - Power Fist 8893521 Manuel De L'utilisateur

V 4.0

FUEL RECOMMENDATIONS

NOTICE! Do not use unapproved gasoline, such as E85. Do not mix oil in
gasoline or modify the engine to run on alternate fuels. This can damage the
engine components. To protect the fuel system from gum formation, mix a
fuel stabilizer into the fuel.
This engine is certified to operate on unleaded gasoline with a minimum of 87
octane/87 AKI (91 RON). Use gasoline without ethanol or similar alcohol based
additives. Gasoline with up to 10% ethanol (gasohol) or up to 15% MTBE
(methyl tertiary butyl ether) may be used if required.
If the engine is routinely operated at altitudes over 5,000 ft (1,524 meters), it
will be necessary to have a qualified technician modify the engine for increased
performance. Fuel should be a minimum of 85 octane/85 AKI (91 RON) to
prevent decreased performance.
The emissions control system for this engine is EM (Engine Modifications).
1. Use only an approved fuel container for refueling the engine.
2. Store fuel out of direct sunlight in a cool and dry location.
3 Inspect container for fuel leaks. Replace any container that leaks.
4. You may occasionally hear a light spark knock or pinging (metallic rapping
noise) while the engine is operating under heavy loads. This is no cause for
concern. If spark knock or pinging occurs at a steady engine speed under
normal load, switch to a premium gasoline or change brands of gasoline. If
spark knock or pinging persists, see an authorized repair centre.
5. Never use stale or contaminated gasoline or an oil/gasoline mixture
designed for two-stroke motors.
HOW TO ADD FUEL
DANGER! Fuel is very flammable. Use extreme care when handling or storing
fuel. An ignition source contacting the fumes or fuel may result in a fire or
explosion and cause fatal or serious injuries to you or a bystander.
1. Refuel outdoors or in a well-ventilated area and immediately wipe up spills.
Fuel can damage paint and plastic.
2. Stop the engine and position equipment on a level surface.
3. Let engine cool at least 2 minutes before removing the fuel cap.
Visit www.princessauto.com for more information
Engine for the 15 Ton Kinetic Log Splitter 8893521
9