Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
LUBRICATION
The winch is permanently lubricated and does not require additional
lubrication. The exception is if the winch is submerged in water. Open the
housing, dry and have a qualified technician re-lubricate the winch.
Lubricate the steel cable with a light oil from time to time to prevent corrosion.
STORAGE
When not in use for an extended period, apply a thin coat of lubricant to the
steel parts to avoid rust. Remove the lubricant before using the tool again.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing uncontrolled
discharge of waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Motor overheats.
Motor does not
turn on.
Motor runs, but
steel cable
drum does not
turn.
Visit www.princessauto.com for more information
12V DC Winch
Possible Cause(s)
Winch running time too
long.
1. Solenoid malfunctioning.
2. Remote damaged.
3. Defective motor.
4. Internal damage or
wear.
5. Remote not properly
plugged in.
6. Battery cables damaged
or not properly
connected.
The clutch is not engaged.
Suggested Solution(s)
Allow winch to cool down
periodically.
1. Tap solenoid to loosen contacts.
2. Replace remote.
3. Check for voltage at armature
port with switch pressed. If
voltage is present, replace motor.
4. Have technician service winch.
5. Check the remote plug is firmly
seated.
6. Replace damaged cables or
reconnect clips to the battery.
Move the clutch handle to the
engaged position. If problem
persists, a qualified technician
needs to check and repair.
8942724
13
Publicité
Table des Matières
