Power Fist 8942724 Mode D'emploi page 9

V1.0
1. Position the vehicle on a flat surface approximately 60 ft distance from a
suitable anchor point, such as a large tree.
2. Unspool the entire cable until only five cable wraps are remaining on the
winch drum.
a. Remove the entire cable if the remaining wraps are overlapping or
there is a gap that the second level of cable can become trapped in.
Rewrap the five wraps carefully without load.
3. Attach a chain or belt around the anchor point that is capable of
withstanding the load. Connect the cable hook to the chain or belt.
4. Shift the vehicle into neutral gear to prevent damage to the transmission.
5. Follow the instructions in Operating The Winch and recoil the rope back
into the winch under at least 1,000 lb (454 kg) of tension. Apply light
pressure to vehicle brake pedal as needed to produce load.
6. Stop approximately every minute to check that the cable is winding level.
Make sure vehicle is in park with parking brake applied before exiting the
vehicle. Do not check, touch or attempt to reposition rope with load on
winch rope.
OPERATING THE WINCH
WARNING! Do not release the clutch while the winch is pulling a load. It may
cause the load to shift or move unexpectedly and the wire may snap with the
unexpected stress. Either may cause death or severe injury to the user or
bystanders.
WARNING! Keep clear of fairlead when operating. Do not try to guide the wire
rope, as your hand may be pulled into the winch and suffer a crushing injury.
Do not operate the winch on slopes. The cable angle should be as close to
vehicle center line as possible.
1. Make sure the operator can safely
control the winch before performing
any functions with it and that they
are familiar with all safety and
operating instructions.
2. Inspect the winch, steel cable and
terminal tackle before each use.
Replace any damaged or frayed
components before use.
Visit www.princessauto.com for more information
12V DC Winch 8942724
Fig. 4
9