A Helmet In Your Size - shark Micro Conseils D'utilisation

a HElMETS in yOUr SiZE
For a helmet to provide effective protection while
remaining comfortable, it has to be perfectly
suited to its user.
Choosing the correct size is essential.
• Measure the circumference of your head with
a tape measure, positioning it about 2 cm above
your eyebrows: this is where your head is the
largest. Once you have taken this measurement,
compare it to the table of sizes. Try the size of
helmet closest to the measurement obtained,
starting with the size smaller than your head
measurement.
If you feel that the contact is too hard, try the
size larger. Your head should be held quite firmly
but you should feel no discomfort.
• Tests for size must be carried out with the chin
strap tightened (please refer to the section on
page 6-7 for instructions on tightening the chin
strap). Check that you have good vertical and
horizontal visibility.
Check that your head can carry out all of these
movements without any particular discomfort.
• Check that when the chin strap is tightened,
the helmet cannot be removed from your head
when you try to move it forward by force. If the
a HElMETS in yO Ur SiZE
helmet comes off or nearly comes off, it is too
big or else the chin strap is not correctly tigh-
tened.
Keep trying on helmets until you find the ideal
size.
WARNING: do not lend your helmet, even for
a short journey, if its size is not perfectly
suitable. For each use of your helmet, it is
absolutely necessary to make sure that the
helmet is well positioned on your head, and
that the chin strap is properly adjusted, fol-
lowing the instructions of this manual (see
page 6-7).
5