Textile Parts - shark Micro Conseils D'utilisation

TExTIlE PARTS

Type
The textile and foam parts providing com-
fort to the SHARK Micro make it easy for you
to appreciate the performance of your helmet
to the best.
The parts in contact with the skin are made
in a fabric that is guaranteed to feel pleasant,
to absorb perspiration well and to resist wear
satisfactorily. We treat surfaces to limit the risk
of mould and bacteria..
Always in one concerns of hygiene, the outer
seal are treated against bacteria, what allows
avoiding their proliferation when we put
the helmet.
Treatment
WARNING! Although they are selected for
their quality of resistance and satisfactory
wear, all the interior padding is subject to
normal wear depending on use and care
and maintenance, the length of use and also
the degree of acidity of your perspiration.
If you note any wear, we advise you to replace
the interior padding in order to keep your hel-
met perfectly clean and comfortable.
10
TExTIlE PARTS
Your SHARK supplier can propose you with
replacement parts and also offer you cheek
pads of different thicknesses and densities,
should the standard selection not correspond
to the contours of your face.
MainTEnanCE
The interior textile parts are washable; it is
important to follow the instructions below
scrupulously to avoid damaging them. The
cheek pads and head section must be hand
washed in warm, soapy water (about 30°).
WARNING! Do not use aggressive deter-
gents but either a product for delicate ma-
terials in low dilution or household soap.
It is essential to dry textile and foam parts
completely before using them. They must be
dried at room temperature. Never iron textile
parts.
For parts with a leather appearance
or textiles attached to safety elements,
use a slightly damp sponge or cloth and
household soap and rinse with clean water.
WARNING! Avoid allowing too much water
to come into contact with polystyrene
parts.
It is essential to ensure that all interior parts
are perfectly dry before using the helmet.