Environmental Protection; Before Startup; Start Up - Kärcher HD 7/11-4 Cage Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 26
Thermostat valve
The thermal valve protects the high-pres-
sure pump from unacceptable heating dur-
ing circuit operation.
Not all unit models are equipped with a
thermostat valve.
Pressure switch
If the lever on the trigger gun is released
the pressure switch turns off the pump, the
high pressure jet is stopped. If the lever is
pulled the pump is turned on again.
Not all unit models are equipped with a
pressure switch.

Environmental protection

The packaging material can be recy-
cled. Please do not place the packag-
ing into the ordinary refuse for disposal, but
arrange for the proper recycling.
Old appliances contain valuable ma-
terials that can be recycled. Please
arrange for the proper recycling of old
appliances. Batteries and accumulators
contain substances that must not enter the
environment. Please dispose of your old
appliances, batteries and accumulators us-
ing appropriate collection systems.
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
www.kaercher.com/REACH

Before Startup

Unpacking
– Check the contents of the pack before
unpacking.
– In case of transport damage inform ven-
dor immediately.
Check oil level
 The oil level must be at the centre of the
oil level display.
20
Activate deaeration of oil container
 Unscrew the screw plug.
 Screw in enclosed oil filling screw.
 Close cover.
Attaching the Accessories
 Connect spray lance to trigger gun.
 Install nozzle with nozzle screw at the
spray lance.
 Screw the high-pressure hose on to the
hand spray gun.
 Fasten the high pressure hose to the
high pressure connection.
Mounting the cable / hose rack
 If required, attach accompanying cable
/ hose rack to the wall.
or
Illustration
 Attach the enclosed cable/hose rack to
the bottom of the device.
Attaching the holder for the trigger gun
Note:
Not all unit models are equipped with the
holder for the trigger gun.
Illustration
 Attaching the support.
Electrical connection
DANGER
Danger of injury by electric shock.
The appliance may only be connected to al-
ternating current.
It is imperative to connect the appliance to
the electric mains by means of a plug. It is
forbidden to permanently connect the appli-
– 5
EN

Start up

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hd 7/16-4 cageHd 9/18-4 cage

Table des Matières