Environmental Protection; Symbols In The Operating In- Structions - Kärcher HWE 860 Mode D'emploi

Please read and comply with
these original instructions prior
English
to the initial operation of your appliance and
store them for later use or subsequent own-
ers.
Contents

Environmental protection . .

Symbols in the operating in-
structions . . . . . . . . . . . . . .
Proper use . . . . . . . . . . . . .
Function . . . . . . . . . . . . . . .
Safety Devices . . . . . . . . . .
Start up . . . . . . . . . . . . . . . .
Operation . . . . . . . . . . . . . .
Shutting down . . . . . . . . . . .
Transport . . . . . . . . . . . . . .
Storing the device . . . . . . . .
Maintenance and care . . . .
Troubleshooting . . . . . . . . .
Warranty . . . . . . . . . . . . . . .
Technical specifications . . .
CE Declaration . . . . . . . . . .
Environmental protection
The packaging material can
be recycled. Please do not
throw the packaging material
into household waste; please
send it for recycling.
Old appliances contain valua-
ble materials that can be recy-
cled; these should be sent for
recycling. Batteries, oil, and
similar substances must not
enter the environment.
Please dispose of your old
appliances using appropriate
collection systems.
Notes about the ingredients (REACH)
You will find current information about the
ingredients at:
http://www.karcher.de/de/unternehmen/
umweltschutz/REACH.htm
Symbols in the operating in-
structions
Danger
Immediate danger that can cause severe
injury or even death.
Warning
Possible hazardous situation that could
lead to severe injury or even death.
Caution
Possible hazardous situation that could
lead to mild injury to persons or damage to
property.
6
Only use appliance to generate hot wa-
-
ter in connection with a high-pressure
cleaner to clean machines, vehicles,
buildings, tools, etc.
If using cleaning agents other than water,
-
check with dealer or customer service.
EN . . 1
When adjusting the temperature ob-
-
serve suitability for the pump and ob-
EN . . 1
jects to be cleaned.
EN . . 1
Danger
EN . . 1
EN . . 1 Risk of injury! Follow the respective safety
regulations when operating at gas stations
EN . . 1
or other dangerous areas.
EN . . 1
EN . . 2
Please do not let mineral oil contaminated
EN . . 2 waste water reach soil, water or the sew-
age system. Perform engine cleaning and
EN . . 2
bottom cleaning therefore only on speci-
EN . . 2
fied places with an oil trap.
EN . . 2
EN . . 2
EN . . 3
EN . . 3
With the HWE 860 you can heat water
-
using electric energy. Its use is sensible
everywhere, where the exhaust air of a
burner poses a problem.
The temperature that can be reached
-
depends on the water volume that was
put through, so the feed capacity of the
used pump (median value see Specifi-
cations).
The set temperature is controlled by a
-
thermostat. If the switch unit is in the
position "manual operation", the heater
is always on via the thermostat. By
switching to the position "automatic op-
eration", the operation readiness also
depends on a switch clock or an exter-
nal remote control.
The appliance also serves as a provi-
-
sion container for the high-pressure
pump.
The liquid softener prevents the calcifi-
-
cation of the heating spiral while operat-
ing with calciferous tap water It is dosed
into the boiler drop by drop. The meter-
ing is set to a medium value by the
manufacturer. This setting can be ad-
justed to local conditions by customer
service.
Safety Devices
Temperature controller
The temperature limiter switches off the
machine if the temperature regulator is de-
fective.
Fill in liquid softener
The white container for the liquid sof-
-
tener is located on the boiler.
If the white container is empty, the red
-
indicator lamp on the switch cabinet will
blink.
Fill container with liquid softener (RM 110).
Proper use
Function
Start up
1
-
EN
Operation
Operating elements
1 Indicator lamp (green) - heater on
2 Switch for manual/automatic operation
3 Indicator lamp (red) - fill level of liquid
softener
4 Main switch
5 Control board
Turning on the Appliance
1 Temperature controller
2 Temperature controller
Open the water supply.
Set temperature regulator to desired
temperature.
Turn the main switch to position "1".
Set switch to manual or automatic oper-
ation.
We recommend the following cleaning tem-
peratures:
Light contaminations
-
30-50 °C
Contaminations containing protein, i.e.
-
in the food processing industry
max. 60 °C
Vehicle cleaning, machine cleaning
-
60 -85 °C
Caution
If the working pressure and the feed speed
are changed, the water temperature will
change as well.
Turn off the appliance
Turn switch for manual/automatic oper-
ation to position "0".