Cleaning And Maintenance - Sonnenkonig METAL BLACK 16 Mode D'emploi

6 Cleaning and maintenance

GB
Over the course of time, dust can accumulate between the spokes of the fan housing, and
on the fan blades. Always begin by trying to remove the dust with a brush and/or vacuum
cleaner. If this does not remove all the dust, you can always dismantle the fan and clean it.
1. Remove the plug from the wall socket.
2. Release the six clips around the rim of the fan housing.
3. Use a small crosshead screwdriver to loosen the screw at the bottom of the fan hou-
sing; hold the bolt at the rear of the fan housing to prevent it from turning.
4. Remove the front grille.
5. Hold the fan blades to prevent them from turning, and use a small crosshead screwdri-
ver to loosen the locking screw. Remove the fan blades from the shaft.
6. Use a crosshead screwdriver to loosen the screws from the motor unit and then remove
the rear grille.
7. Clean the dismantled parts and the base with a damp cloth. Dry thoroughly with a
dry cloth.
8. Clean the motor unit with a dry cloth.
– Verify that the appliance is not connected to the power supply before you clean it.
– Never use corrosive or scouring cleaning agents or sharp objects (such as knives or
hard brushes) to clean the appliance.
– Be careful not to cut yourself on the sharp edges of the fan blades.
50