Operation And Storage; Cleaning And Maintenance - Sonnenkonig RETRO Mode D'emploi

4. OPERATION AND STORAGE

• Power the fan with a USB cable or insert 4 AA batteries into the battery compartment.
EN
• Move the on/off switch to select high/low power level.
• When the oscillation switch is pulled up, the fan will stay in the current position.
When pushing down the oscillation switch, the fan will oscillate again.
• Turn the thumb screw to adjust the fan angle up/down for your desired position.
• When finished using, move the power switch of the fan into the "OFF" position
Attention:
Do not use any other power source than the USB cable or AA batteries.
Disconnect the USB cable when not using the fan.
Laptop computer users' note:
When plugged into your laptop USB port, this USB fan gets its power from the laptop com-
puter. To avoid laptop battery drain, plug the laptop into a receptacle while using this fan.
Battery warnings:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) bat-
teries.
• Do not install the batteries backwards. Install batteries with the proper polarity (+/-).
There is a risk of explosion or leakage if batteries are installed incorrectly.
• Always remove discharged batteries from the product to avoid damage by possible
battery leakage.
• Do not throw batteries into fire as they may explode or leak.
• Do not short circuit battery terminals.

CLEANING AND MAINTENANCE

Follow these instructions to correctly and safely care for your fan. Please remember:
• Always unplug the fan before cleaning or assembling.
• Do not allow water to drip on or into the fan motor.
• Be sure to use a soft cloth, moistened with a mild soap solution.
• Do not use petrol, thinners or benzene as cleaning agents.
30