Work Instructions - Güde AGS 3.6-130-03 Mode D'emploi

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Please turn the device immediately off when the tool used

gets blocked! Do not turn the device on again when the

tool is still blocked. This could cause bounce back with a

high reaction moment. Determine and remove the cause

of the blocking of the tool used while respecting the

safety instructions.

The possible causes may be:

• it is tilted in the workpiece to be machined

• it has pierced through the material to be machined

• the power tool is overloaded

Battery

Never use the charger in moist or wet conditions. Suitable

for indoor areas only.

Make sure the system voltage corresponds to the charger

type plate details. There is a risk of electric shock.

Cable connections to be separated by pulling the plug only.

Pulling the cable could damage both the cable and plug.

As a result, electric safety would no longer be guaranteed.

Never use the charger when the cable, plug or the machine

is damaged by external influences. In case damage let

repaired in authorized workshop

The Güde charger to be used only to charge the battery. There

can be malfunction or fire if different chargers are used.

Vapours may leak out in case of unauthorised use or when

using a damaged accumulator. Bring fresh air and seek

medical advice if experiencing difficulties. Vapours may

irritate the respiratory system.

Risk of fire! Risk of explosion!

Never use damaged, defective or deformed accu-

mulators. Never open or damage the accumulator

or let it fall on the ground.

Never charge the battery in an environment with

acids and easily flammable materials.

Protect the battery against heat and fire.

Battery to be used at the ambient temperatures

between 10°C and +40°C only.

Never put the battery on heaters and do not

expose it to strong sunlight for a long time.

After being subject to heavy load, let the battery

cool down first.

Short circuit - do not bridge the accumulator

contacts with metal parts.

The accumulator must be packaged (plastic bag,

box) or accumulator contacts must be sealed up

for accumulator disposal, transport or storage.