Screwdriver Safety Warnings; Additional Safety And Working Instructions - Güde AGS 3.6-130-03 Mode D'emploi

ENGLISH
20
users.
e) Treat electric tools carefully. Check whether the mo-
ving parts work perfectly and do not drag, whether
not broken or damaged to such an extent that func-
tioning of electric tools could be affected. Have any
damaged parts repaired before using the machine.
Many accidents are caused by poorly maintained power
tools.
f) Keep cutting tools sharp and clean. Properly maintai-
ned cutting tools with sharp cutting edges are less likely
to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations dif-
ferent from those intended could result in a hazardous
situation.
5) Using and treatment of cordless tools.
a) Charge the batteries only in chargers recommended
by the manufacturer. Risk of fire for a charger suitable
only for a certain type of batteries or, as appropriate,
accumulators, if used for other accumulators.
b) Use only such accumulators in this electric appliance
that have been designed for this appliance. Use of
other accumulators may lead to injuries and risk of fire.
c) Do not leave an accumulator not being used near
office clips, coins, keys, nails, screws or other small
metal items that could cause contact bridging. Short
circuit between accumulator contacts may result in
burns or fire.
d) Liquid may leak from an accumulator if used impro-
perly. Prevent contact with such liquid. Rinse an
affected body part with water in case of accidental
contact. If liquid gets to your eye, seek medical
advice. Liquid leaking from a battery may cause skin
irritation or burns.
6) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintai-
ned.

Screwdriver safety warnings

Hold power tool by insulated gripping surfaces, when
performing an operation where the fastener may
contact hidden wiring. Fasteners contacting a „live" wire
may make exposed metal parts of the power tool „live" and
could give the operator an electric shock.
Additional Safety and Working
Instructions
Clamp your workpiece with a clamping device. Unclamped
workpieces can cause severe injury and damage.
Do not use the device near flammable liquids or gases. Risk
of fire and explosion in case of short circuit.