Remote controller
Handling the remote controller
Location of the remote controller
CAUTIONS:
The air conditioner will not operate if curtains, doors or other materials block the
signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose the remote
controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air
conditioner may not function properly. Use curtains to prevent the sunlight from
falling on the receiver.
If other electrical appliances react to the remote controller, either move these
appliances or consult your local dealer.
Replacing batteries
Use the remote controller within a distance of 8 meters from the appliance,
pointing it towards the receiver. Reception is confirmed by a beep.
The remote controller is powed by two dry batteries(R03/LR03X2) housed
in the rear part and protected by a cover.
1.
Remove the cover by pressing and sliding off.
2.
Remove the old batteries and insert the new batteries,placing
the(+) and (-) ends correctly.
3.
Reattach the cover by sliding it back into position.
NOTE: When the batteries are removed, the remote controller erases all
programming. After inserting new batteries, the remote controller must be
reprogrammed.
45