Climadiff CLIMA5K1 Notice D'utilisation page 44

of cooling mode; when environmental temperature is lower than 15℃, the operation state is
the same as that of fan mode.

In the dehumidifying mode, the motor will work in low speed, and cannot be adjust.

In this mode, the temperature cannot be adjust.

Do not put the duct to window
Sleep/Eco operation:

This feature can be activated from the remote control ONLY. To activate SLEEP feature, the
set temperature will increase(cooling) or decrease(heating) by 1°C/2°F

(or 1°F) in 30 minutes. The set temperature will then increase(cooling) or decrease(heating)
by another 1°C/2°F (or 1°F) after an additional 30 minutes. This new

temperature will be maintained for 7 hours before it returns to the originally selected
temperature. This ends the Sleep mode and the unit will continue to operate as originally
programmed.

NOTE: This feature is unavailabe under FAN or DRY mode.
Follow me/Temp sensing (optional)

NOTE: This feature can be activated from the remote control ONLY. The remote control
serves as a remote thermostat allowing for the precise temperature control at its location. To
activate the Follow Me/Temp Sensing feature, point the remote control towards the unit and
press the Follow Me/Temp Sensing button. The remote control will send this signal to the air
conditioner until press the Follow Me/Temp Sensing button again.

If the unit does not receive the Follow Me/Temp Sensing signal during any 7 minutes
interval, the unit will exit the Follow Me/Temp Sensing mode.

NOTE: This feature is unavailable under FAN or DRY mode.
Auto-restart (optional)

If the unit breaks off unexpectedly due to the power cut, it will restart with the previous
function setting automatically when the power resumes.
Air flow direction adjustment
Adjust the air flow direction manually:

The louver can be set to the desired position manually.

Do not place any heavy objects or other loads on the louver, doing so will cause damage to
the unit.

Ensure the louver is fully opened under heating operation.

Keep the louver fully opened during operation.
44