2 Hardware Installation
System requirement
LAN or WAN Internet to connect server, via PC Ethernet ( network card or network cable) TCP/IP protocol (Windows
/NT/2000/XP or later) connect , suggest Internet Explorer 5.0 version or later.
Monitor and PC configuration:
CPU: P III or later, RAM: 512M or later ( above DirectX8.1)
Monitor: 17", 1920×1080 resolution
Operation system: Windows NT, Windows2000, Windows XP、 Windows 7or later.
Installation environment
Installation environment requirements
Far away from humid or high-temperature environment; Choose proper place for ventilation; avoid installing on shaky place, and try to stay
away from heat device.
Recommend operating environment
-20°C~55°C
Hardware installation steps
Please make sure LAN and WAN are working in order before installation of the Network High Speed Dome. After checked all the network
system in good condition, keep your hands clean and dry, following the steps below.
Unpack the box to check the goods
Take out all goods which needed for installation from the box
Take off the protection cover and insert the SD card. Please refer to the SD card installation steps below.
Figure 2-1
Figure 2-2
2
Remove the ornament
screws (2pcs), then take it off
Loosen the screws of
horizontal installation panel
(4pcs), then put up the panel
for a little