Comelit PPTZ120IRC Mode D'emploi page 13


Voice intercom：Connect sound pick-up device on the audio input port and active loudspeaker on the audio output port, then click
the talkback icon. Turn on the voice intercom switch and the icon shows as
Speed Dome can be performed. Audio input setting as default mode.

SNAP: click button, snap the current image and save it in .JPG format automatically to the storage directory of snapped
images. The default path is C:\Program Files\PREVIEW, and the storage path is changeable.

Full Screen: press
screen display

Record: ON/ OFF selectable. When select ON, the icon turn blue as
appointed files

Alarm Info: Warns light flashing when camera device inform alarm. Support kinds of alarms record, and setup or remove the alarm
setting,clear the alarm information.

Zoom-in: Use the mouse to do local zoom for the video display area by scrolling the mouse wheel.

PTZ control: Up/ down/ left/ right/ auto/ adjust the PTZ rotate speed, etc. As figure 3-8.

Lens control: Do scaling, focus, iris operation, as figure 3-8.

Brightness: adjust the image brightness. As in the figure 3-9.

Contrast: adjust the image contrast. As shown as in the figure 3-9.

PTZ setting: preset setting, cruise, track setting, linear scan, idle ope , IR light as figure 3-10.
Preset setting: Adjust the camera to the appointed angle and location through directional buttons and then select a preset
number on the preset drop down list, click
Call preset: Select a preset number which needed to call on the preset drop down list, then click
Cruise: 255 presets addable, stay time 1-255s adjustable, cruise speed 1-7 levels selectable. All cruise tracking can be call
and delete independently
Clear cruise: Click
Call cruise: Click
Tracking path setting: Select a number at the tracking drop down list, click
Call tracking path: Select a number at the tracking drop down list, click
Linear: Select a number at the linear drop down list, click
operation, then click
and the vertical angle depend on the final position, linear path is two point minimum path
Call linear: Select a number at the linear drop down list, click
Idle operation: Idle operation include preset setting, cruise scan, tracking, scan. Click
time is 1-15 min selectable, click
setting completed. When set idle ope successfully, speed dome camera will do idle operation after the set idle time
IR light: Auto/ Manual selectable, when select Auto, it will turn on the IR led according to the zoom module multiples, near open
for 1X, middle-open for 2-4X, far open for 5X or 5X later. When select Manual, there All close/near open/ middle open/ near
middle open/ far open/ far near open/ middle far open/ all open totally 8 kind of choices
3D Position: 3D position function can be opened or closed
button or click right mouse button to live preview in full screen, press the Esc key or remove clip to exit full
to clear all cruise scan setting
to call set cruise scan.
to save and exit the tracking path setting.
to save and exit the linear scan setting. Linear scan only supported horizonal scan
and device do video recording and saved in the
to set it
to set the linear scan initial position and do a serious PTZ
to call linear scan
to save the idle operation setting, click
9
, the talkback between PC and Network High
to call it.
and do a serious PTZ operation, then click
to call tracking path
to set idle operation and the idle
to verify the idle operation