Motion Detection - Comelit PPTZ120IRC Mode D'emploi

Motion Detection

Network High Speed Dome "Motion Detection" setting interface as figure 3-18.

Enable: Select whether open the motion detection function.

Alarm Schedule: Set the alarm schedule from Monday to Sunday.

Mask Set: In the "Mask Set" preview interface, press and darg the left mouse button, then set the area needed to be detected.

Clear: Click Clear to clear the current detective areas.

Sensitivity: The higher of the sensitivity, the obvious of the motion detective.

Email: Send Email to appointed mailbox when alarm triggered.

Snap: Snapshot and install the picture in the HDD when alarm triggered.

Alarm Output: There is a warner connect the alarm output port, alarm triggered the embedded relay switch to make alarm output.

Enable PTZ: Alarm input to link the PTZ motion.

Preset: Alarm input to link the preset.

Snap Interval: Set the snapshot interval time.

Snap Count: Set the snapshot count in every second.
After all parameters setting completed, click "Save" and then it comes into effect immediately.
Figure 3-18
17