Network Settings - Comelit PPTZ120IRC Mode D'emploi

Network Settings

Network High Speed Dome "Network Settings" interface as figure 3-20.

IPV4: IP protocol version No. is 4

IPV6: IP protocol version No. is 6

Static IP: The device IP address is permanent
 DHCP: Click DHCP, when turn on the router's DHCP, the camera will get the IP address from router automatically

IP address: Input the corresponding numbers to change the IP address

Subnet Mask: Input the corresponding IP subnet mask

Gateway: Input the corresponding gateway address

DNS 1: DNS server address

DNS2: DNS server standby address

SNMP: To detect whether it will cause any management attention as device connected on the network

SNMP Manager IP: Input the corresponding SNMP manager IP address

HTTP Port: Input the corresponding port ( Default is 80)

HTTPS Port: Input the corresponding port ( Default is 443)

RTSP Port: Use domain name to access and login device need mapping RTSP, default port is 554

RTMP Port: Use domain name to access and login device need mapping RTMP, default port is 1935

Enable UPnp: When click Enable UPnp, the device and HTTP port will mapping to the router automatically

Device Port: Input the corresponding device port (Default is 5050)
After all parameters setting completed, click "Save" and then it comes into effect immediately.
Figure 3-20
19