Jci1: Chassis Intrusion Connector; Jdash1 : Tuning Controller Connector - MSI MEG X570S UNIFY-X MAX Présentation Rapide

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the chassis.
2. Close the chassis cover.
3. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > SETTINGS > Security > Chassis Intrusion Configuration.
2. Set Chassis Intrusion to Reset.
3. Press F10 to save and exit and then press the Enter key to select Yes.

JDASH1 : Tuning Controller connector

This connector is used to connect an optional Tuning Controller module.
30
Overview of Components
Normal
(default)
1 No Pin
3 MCU_SMB_SCL
5 VCC5
7 PWSW+
9 NC
11 NC
13 CLRCMOS_EN
Trigger the chassis
intrusion event
2 14
1
13
2
4 MCU_SMB_SDA
6 Ground
8 RESET+
10 OC_FS_R
12
14
NC
NC
NC