Jci1: Chassis Intrusion Connector; Ez Debug Led: Debug Led Indicators - MSI H170M BAZOOKA Présentation Rapide

JCI1: Chassis Intrusion Connector

This connector allows you to connect the chassis intrusion switch cable.
Using chassis intrusion detector
1. Connect the JCI1 connector to the chassis intrusion switch/ sensor on the
chassis.
2. Close the chassis cover.
Go to BIOS > Security > Chassis Intrusion Configuration.
3.
4. Set Chassis Intrusion to Enabled.
5. Press F10 to save and exit and then press the Enter key to select Yes.
6. Once the chassis cover is opened again, a warning message will be displayed on
screen when the computer is turned on.
Resetting the chassis intrusion warning
1. Go to BIOS > Security > Chassis Intrusion Configuration.
Set Chassis Intrusion to Reset.
2.
3. Press F10 to save and exit and then press the Enter key to select Yes.

EZ Debug LED: Debug LED indicators

These LEDs indicate the status of the motherboard.
Normal
(default)
CPU - indicates CPU is not detected or fail.
DRAM - indicates DRAM is not detected or fail.
VGA - indicates GPU is not detected or fail.
Trigger the chassis
intrusion event
Overview of Components
17