Machine Start And Stop; Machine Operation (Scrubbing/Drying) - Alto SCRUBTEC R 361 Manuel D'utilisation

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Turn the ignition key (41) to "I" and press the forward/reverse gear pedal (3). Check that the green warning light (37a) turns on.
If the yellow or red warning light (37b or 37c) turns on, turn the ignition key back to "0" and charge the batteries (see the
procedure in Maintenance chapter).
3. Drive the machine to the working place, by starting it with the hands on the steering wheel and by pressing the pedal (3).
The drive speed can be adjusted from zero to maximum speed according to the pressure on the pedal (3).
4. The forward/reverse gear is selected with the switch (39) on the right side of the dashboard.
NOTE
The driver's seat (25) is equipped with a safety sensor which allows the machine to be moved with the pedal (3) only
when the operator is on the driver's seat.
NOTE
The machine is equipped with an anti-tilting safety system that reduces the speed when turning, irrespectively of the
pressure on the pedal.
The reduction of speed when turning is not a malfunction but a characteristic that improves the machine stability in
every condition.
5. Lower the brush/pad-holder deck and the squeegee by pressing the pedal (34).
6. Press the solution flow control switches (40) as necessary, depending on the type of cleaning to be performed.
7. Start scrubbing, by starting it with the hands on the steering wheel (2) and by pressing the pedal (3) as necessary.
Stopping the machine
8. Release the pedal (3).
9. It is not necessary to lock the machine during stopping or parking, because the electromagnetic brake (27) turns on automati-
cally when the gear pedal is not pressed.
10. Lift the brush/pad-holder deck and the squeegee by pressing the pedal (34).

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. If necessary, vary the solution quantity by pressing the switches (40).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, Alto suggests to go near the walls with the right side of
the machine as shown in figure 2.
A
9097421000(1)2008-01 A
Figure 2
SCRUBTEC R 361 - R 366 - R 371 - R 371 C
USER MANUAL
B
ENGLISH
P100160
15