Before Machine Start-Up - Alto SCRUBTEC R 361 Manuel D'utilisation

BEFORE MACHINE START-UP

WARNING!
When starting the machine, check that between the deck (4 or 5) and the machine, or between the squeegee
(12) and the machine, there is no foreign material which may prevent the deck or squeegee from lifting. This
check is necessary because, if the machine has been turned off without lifting the deck and the squeegee,
the deck and the squeegee will lift automatically at next machine start-up.
Deck installation/removal
The machine can be equipped with either the brush/pad-holder deck (4) or the cylindrical brush deck (5).
For deck installation/removal see the procedure in Maintenance chapter.
NOTE
When the deck is installed/removed, it may be necessary to change the squeegee too, because they must have the
same width. For correct matching of deck and squeegee, see the Technical Data paragraph.
Brush/pad-holder installation/removal (only for SCRUBTEC R 361 / R 366 / R 371)
1. According to the kind of cleaning to be performed, the machine can be equipped either with brushes (88) or pad-holders (89)
with pads (90) together with the appropriate deck.
2. For the installation/removal, proceed as follows.
Insert the ignition key (41) and turn it to "I".
WARNING!
Before turning on the switch (34), always check that between the deck (4) and the machine there is no for-
eign material which may prevent the deck from lifting.
3. Lift the deck by pressing the switch (34).
4. Turn the ignition key (41) to "0" and remove it.
5. Install the brushes/pad-holders (88 or 89) and lift them completely, then turn them clockwise (see the arrows 88 and 89) until
the end of stroke.
6. To remove the brushes/pad-holders, perform steps 2 to 5 in the reverse order.
Types of brushes available
305 mm-models
PROLENE
MIDLITE GRIT 180
MIDGRIT 240
PROLITE
UNION MIX
Brush/pad application guide
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Polishing:
Rubber tiles
Marble
Vinyl tiles
9097421000(1)2008-01 A
330 mm-models
PROLENE
MIDLITE GRIT 180
MIDGRIT 240
PROLITE
UNION MIX
MIDLITE GRIT 180 MIDGRIT 240
SCRUBTEC R 361 - R 366 - R 371 - R 371 C
USER MANUAL
370 mm-models
PROLENE
MIDLITE GRIT 180
MIDGRIT 240
PROLITE
UNION MIX
PROLENE PROLITE
ENGLISH
UNION MIX
13