Alto SCRUBTEC R 361 Manuel D'utilisation page 68

ENGLISH
Cylindrical brush installation/removal (only for SCRUBTEC R 371 C)
7. Insert the ignition key (41) and turn it to "I".
WARNING!
Before turning on the switch (34), always check that between the deck (5) and the machine there is no for-
eign material which may prevent the deck from lifting.
8. Lift the deck by pressing the switch (34).
9. Turn the ignition key (41) to "0" and remove it.
10. On both sides of the machine, unscrew the knobs (97) and remove the side skirt assembly (96).
11. Unscrew the knobs (101) and remove the lids (100) by pushing the knobs downwards.
12. Install the cylindrical brushes (99).
The cylindrical brushes can be installed on either sides.
13. Install the lids (100) and fasten them with the knobs (101).
14. To remove the cylindrical brushes, perform steps 7 to 13 in the reverse order.
Types of cylindrical brushes available
145 x 690 mm-model
PROLENE
MAGNA GRIT 46
DYNA GRIT 80
MIDLITE GRIT 180
PROLITE
UNION MIX
Cylindrical brush application guide
Models
General cleaning:
Concrete
Terrazzo floor
Ceramic tiles/quarrystones
Marble
Vinyl tiles
Rubber tiles
Squeegee installation
NOTE
The squeegee and the deck must have the same width. For correct matching of deck and squeegee, see the
Technical Data paragraph.
15. Install the squeegee (12) and fasten it with the handwheels (15), then connect the vacuum hose (11) to the squeegee.
16. Adjust the squeegee with the handwheel (16) so that the rear blade (18) touches the floor along all its length and the front
blade (17) is slightly lifted from the floor.
Solution tank filling
17. Open the cover (58).
18. Fill the solution tank (61) with a solution suitable for the work to be performed.
Do not fill the solution tank completely, leave a few centimetres from the edge.
Always follow the dilution instructions on the label of the chemical product used to prepare the solution.
The solution temperature must not exceed 40°C.
WARNING!
Use only low-foam and non-flammable detergents, intended for automatic scrubber applications.
Driver's position adjustment
21. Using the lever (1), adjust the inclination of the steering wheel (2) to reach a comfortable position.
14
USER MANUAL
MAGNA GRIT 46 DYNA GRIT 80
SCRUBTEC R 361 - R 366 - R 371 - R 371 C
MIDLITE GRIT 180 PROLENE PROLITE UNION MIX
9097421000(1)2008-01 A