Alto SCRUBTEC R 361 Manuel D'utilisation page 58

ENGLISH
– Carefully read all the instructions before performing any maintenance/repair procedure.
– Before using the battery charger, ensure that frequency and voltage values, indicated on the machine serial number
plate, match the electrical mains voltage.
– To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is plugged in.
Disconnect the machine from the electrical mains when not in use and before performing maintenance procedures.
– To avoid electric shock, do not expose to rain. Store the machine indoors.
– Do not allow to be used as a toy. Close attention is necessary when used near children.
– Use only as shown in this Manual. Use only Alto's recommended accessories.
– Do not use the machine if the battery charger cable or plug is damaged. If the machine is not working as it should,
has been damaged, left outdoors or dropped into water, return it to the Service Center.
– Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as a handle. Do
not close a door on the battery charger cable, or pull the battery charger cable around sharp edges or corners. Do not
run the machine on the battery charger cable. Keep the battery charger cable away from heated surfaces.
– Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the machine moving
parts.
– Do not smoke while charging the batteries.
– Do not leave the machine unattended without being sure that it cannot move independently.
– Do not use the machine on slopes with a gradient exceeding the specifications.
– Do not wash the machine with direct or pressurised water jets, or with corrosive substances.
– Do not use the machine in particularly dusty areas.
– While using this machine, take care not to cause damage to other people, especially children.
– Do not put any can containing fluids on the machine.
– The machine storage temperature must be between 0°C and +40°C.
– The machine working temperature must be between 0°C and +40°C.
– The humidity must be between 30% and 95%.
– Always protect the machine against the sun, rain and bad weather, both under operation and inactivity condition.
– Do not use the machine as a means of transport.
– Do not use the machine on slopes with an inclination higher than 16%.
– Do not allow the brushes to operate while the machine is stationary to avoid damaging the floor.
– In case of fire, use a powder fire extinguisher, not a water one.
– Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
– Do not tamper with the machine safety guards and follow the ordinary maintenance instructions scrupulously.
– To move the machine by hand the electromagnetic brake must be unlocked. When the operation is over, the electro-
magnetic brake must be activated again. Do not use the machine when the electromagnetic brake is deactivated.
– Do not remove or modify the plates affixed to the machine.
– In case of machine malfunctions, ensure that these are not due to lack of maintenance. If necessary, request assist-
ance from the authorised personnel or from an authorised Service Center.
– If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
– To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant chapter of this
Manual, must be performed by the authorised personnel or by an authorised Service Centre.
– The machine must be disposed of properly, because of the presence of toxic-harmful materials (batteries, etc.), which
are subject to standards that require disposal in special centres (see Scrapping chapter).
– Do not allow any object to enter into the openings. Do not use the machine if the openings are clogged. Always keep
the openings free from dust, hairs and any other foreign material which could reduce the air flow.
– This machine cannot be used on roads or public streets.
– Pay attention during machine transportation when temperature is below freezing point. The water in the recovery tank
or in the hoses could freeze and seriously damage the machine.
– Use brushes and pads supplied with the machine and those specified in the User Manual. Using other brushes or
pads could reduce safety.
– When WET batteries are installed on the machine, do not tilt the machine for more than 30° from the horizontal plane
to prevent the highly corrosive acid from leaking out of the batteries. If the machine must be tilted to perform any
maintenance procedure, remove the batteries.
4
USER MANUAL
SCRUBTEC R 361 - R 366 - R 371 - R 371 C
WARNING!
9097421000(1)2008-01 A