Maintenance; Scheduled Maintenance Table; Machine Working Hour Check - Alto SCRUBTEC R 361 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following chart provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
WARNING!
The procedures must be performed with the machine off and the battery disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Centre.
This Manual describes only the easiest and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can
be consulted at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Squeegee cleaning
Brush cleaning
Tank and vacuum grid with float cleaning
Battery charging
Squeegee blade check and replacement
Side skirt check
Solution filter cleaning
Battery (WET) fluid level check
Screw and nut tightening check
Check and adjustment of driving belts between motors and
cylindrical brushes
Squeegee cable sliding shoe lubrication
Electromagnetic brake efficiency check
Brush/pad-holder motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement
(1) And after the first 8 working hours.
(2) This maintenance procedure must be performed by Alto authorised Service Center.

MACHINE WORKING HOUR CHECK

1.
Insert the ignition key (41) and turn it to "I".
2.
In the first 5 seconds of machine operation, the display (38) shows the total number of working hours (scrubbing/drying) per-
formed by the machine.
Turn the ignition key (41) to "0".
18
USER MANUAL
SCRUBTEC R 361 - R 366 - R 371 - R 371 C
Daily, after using
Weekly
the machine
Every six
Yearly
months
(1)
(2)
(2)
(2)
(2)
(2)
(2)
9097421000(1)2008-01 A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Scrubtec r 366Scrubtec r 371Scrubtec r 371 c

Table des Matières