Vacuum Operation; Pump Operation; Know Your Machine - Nilfisk WP630 Manuel D'utilisation

A - ENGLISH
SET-UP:
Connect the vacuum/recovery hose to the vacuum inlet hose barb on the recovery tank. Connect the dump hose to the hose fi tting on the rear of
the machine. Check fi lters. Put the lid on the
recovery tank. Plug the machine into a grounded outlet.

VACUUM OPERATION:

A switch is provided for each vacuum motor. The machine can operate with either one, or both, vacuum motors running.
VACUUM SHUT-OFF:
When the recovery tank is full, the fl oat system will shut off power to the vacuum motor(s) to prevent water from entering the motor(s). The fl oat
may not work properly if it is extremely dirty or if there is foam in the tank. Use a defoamer any time foam is present. Once the tank has emptied
suffi ciently, the vacuums will come back on automatically.

PUMP OPERATION:

Always be sure to uncap the pump-out fi tting and connect the dump hose before turning the pumps on. Failure to do so may result in blown hoses
or loose fi ttings; water will damage motors and switches. The two diaphram pumps on your WP630 work together. When you turn the pump
switch on, both pumps will run, and they will continue to run until you turn them off. Do not let the pumps run dry for extended periods of time.

KNOW YOUR MACHINE

1 Vacuum Cover
2 Recovery Hose Connection Point
3 Recovery Tank Access Lid
4 Latch
5 Castor
6 Switches
7 Drain Hose
8 Pump Out Hose Connection
9 10" Wheel
2
A - 4
INSTRUCTIONS FOR USE
1
3
4
5
WP630 - 56042669
9
7
6
8
9/2016