Hardware Kit; General Assembly Information; Assembly Steps - Tunturi Cardio Fit Row R30 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
The package contains the fasteners as
shown in figure.
If a part is missing, contact your dealer
GENERAL ASSEMBLY
WARNING
Assemble the equipment in the given
order.
Carry and move the equipment with
at least two persons.
CAUTION
Place the equipment on a firm, level
surface.
Place the equipment on a protective
base to prevent damage to the floor
surface.
Allow at least 100 cm of clearance
around the equipment.
8

HARDWARE KIT

INFORMATION
Refer to the illustrations for the correct
assembly of the equipment.

ASSEMBLY STEPS

Assembly step 1
Fit front stabilizer.
Connect the sensor wires with the
console.
Fix the console to the console
bracket. (use the two screws already
present on the console rear cover).
Remark:
Avoid the wires to damage during
assembly

Publicité

Table des Matières
loading

Table des Matières