Measuring Resistance; Continuity Test With Buzzer - Metrix MX 350 Notice De Fonctionnement

Masquer les pouces Voir aussi pour MX 350:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
2.
Open the clamp by pressing the trigger.
3.
Place the clamp around the conductor to be
measured and release the trigger; check that
the clamp is correctly closed.
4.
Read the measurement result on the display
unit.
For safety reasons, disconnect the measuring
leads before performing this operation. The clamp
must be positioned around a single conductor in a
circuit, with the risk of rendering the measurement
incorrect. The best measurement is obtained with
the conductor centred in the middle of the jaws.

Measuring resistance

1.
Set the switch to
2.
Connect the red test lead to the
terminal and the black test lead to the
input terminal.
3.
Apply the probe tips on the points where the
resistance is to be measured.
4.
Read the result on the display unit

Continuity test with buzzer

1.
Set the switch to
2.
Connect the red test lead to the
terminal and the black test lead to the
input terminal.
3.
Apply the probe tips on the circuit to be
tested.
input
input
23

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mx 355

Table des Matières