Mesto 3555B Notice D'utilisation Originale page 23

be treated switch between the available spraying modes D1 to D4
selector switch [20] on the operating unit [8] upwards or downwards
A brief spray is output each time the switch [21] on the spray gun [4] is operated. Please
refer to Table 2 for the applied quantity of liquid as a function of the spray mode set.
Spray mode
+
+
+
of sprays applied. To display the number of sprays on the display of the operating unit
[8], turn the selector switch [20] to the right or left
your device. Repeated operation of the selector switch [20] will display the number of
sprays in the respective spray mode
+
To check correct dosing of your device, make a note of the counter readings when
replacing the tank. Apply the contents of the tank fully. Compare the amount of plant
protection product actually applied with the amount theoretically determined from the
number of sprays applied.
8. If the plant protection product in the tank has been applied fully, replace the empty tank.
This always involves removing it from the device. Unscrew the tank cap [2] belonging
to the dosing system. Remove the original cap from a new tank and use it to close the
empty tank.
.
Applied quantity of liquid in ml
per switch operation
0.20
®
.
.
18
by moving the
.