Table des Matières
Publicité
Getting started
Before first use. Remove all
1.
GB
adhesive remains and gently rub
with a dampened cloth. Position the
steam generator iron horizontally
on the ironing-board or on a heat
resistant, secure surface at the same
height as an ironing-board. Unwind
and straighten the power cord and
the steam cord. When turned on for
the first time, temporary vapours/
odours may occur.
B
C
Connect the steam generator
4.
iron to the mains supply. Turn the
power knob (A) clockwise to MAX.
Turn the temperature selector
clockwise to maximum setting (B).
The temperature indicator light on
the iron will illuminate. Then, select
a steam level by turning the
between low -
level control knob
medium - high steam (C).
24
DBS7146GR_Safirina_SteamStation_TOP_AEG.indd 24
Open the water tank lid. Fill
2.
the water tank using cold water.
It is recommended to use AEG
AquaSense filtered water, taking
out impurities like limescale.
Otherwise use destilled water. If
the tap water is particularly hard,
use a mix of 50% destilled water
and 50% tap water. Empty the
water tank to rinse out any foreign
particles which may remain from
the manufacturing process.
A
5. The steam generator is equipped with
ECO setting.
Ironing on ECO setting ( ECO setting
needs to be selected on both temperature
dial and control panel) instead of
MAX setting saves up to 20 % energy
consumption. ECO setting is using lower
pressure, producing lower steam rate but
steam
delivering faster heat-up time.
Always refill the water tank to
3.
MAX level using cold water (A).
Replace the water tank lid.
Caution! Never operate the
appliance without any water in the
tank.
6.
When the temperature indicator
light turns on, the steam station is
pre-heating. When the light turns off,
it is ready to be used. Press and hold
the steam button for some seconds
to get steam. Then hold for a few
more seconds in order to clean the
steam generating system.
2015-05-25 10:16:55
Publicité
Table des Matières
