Getting Started - AEG 4Safety PRECISION DB61 Série Mode D'emploi

Getting started

1. Before first use. Remove all adhesive
GB
remains and gently rub with a
dampened cloth. Rinse water tank
to remove foreign particles. When
turned on for the first time, temporary
vapours/odours may occur.
B
A
4. Using the spray mist and steam
jet function. Ensure that water tank
is at least 1/4 full. Use spray mist to
pre-dampen fabrics by pressing spray
button several times to release a fine
mist (A). To use the steam jet function,
ensure that tank is at least 1/2 full.
Press steam jet button several times to
prime pump (B).
20
2. Filling steam iron with water.
Make sure plug is removed from
power outlet. Turn the temperature
selector to '0' and open the filling
aperture cover. Let the iron rest on the
heel. Fill water up to maximum level.
Close cover. Caution: Do not exceed
the maximum water level.
5. Steaming hanging items. Vertical
steam jet function is ideal for steaming
curtains, suits and delicate fabrics.
Hang item on a hanger, hold iron at a
distance of 10–20 cm and press steam
jet button.
3. Plug power cable into a power
outlet. Power indicator light turns
on. Set temperature by turning
temperature selector to adequate
choice. When the light turns green, the
iron is ready to use.
8 min
30 sec
6. 3-way Auto-OFF. If iron is left
unattended on soleplate or on the
side, it turns off after 30 seconds. If left
unattended on the heel, it turns off
after 8 minutes. To turn on, just begin
to iron again. The indicator light will
flash yellow and the sound alert will
beep 6 times before Auto-OFF.
30 sec