Getting Started - AEG 4Safety PLUS DB52 Série Mode D'emploi

Getting started

1. Before first use. Remove all adhesive
GB
remains and gently rub with a
dampened cloth. Rinse water tank
to remove foreign particles. When
turned on for the first time, temporary
vapours/odours may occur.
B
4. Using the spray mist and steam
jet function. Ensure that water tank
is at least 1/4 full. Use spray mist to
pre-dampen fabrics by pressing spray
button several times to release a fine
mist (A). To use the steam jet function,
ensure that tank is at least 1/2 full.
Press steam jet button several times to
prime pump (B).
20
2. Filling steam iron with water.
Make sure plug is removed from
power outlet. Turn steam selector to
Dry setting and open filling aperture
cover. Using beaker provided, pour
water up to maximum level. Close
cover. This product is appropriate for
use with tap water. It is recommended
to use destilled water or a mix of 50%
destilled, 50% tap water.
A
5. Steaming hanging items. Vertical
steam jet function is ideal for steaming
curtains, suits and delicate fabrics.
Hang item on a hanger, hold iron at a
distance of 10–20 cm and press steam
jet button.
3. Plug power cable into a power
outlet. Power indicator light turns
on. Set temperature by turning
temperature selector to adequate
choice. When the light turns off, iron is
ready to be used.
8 min
30 sec
6. 3-way Auto-OFF. If iron is left
unattended on soleplate or on the
side, it turns off after 30 seconds. If left
unattended on the heel, it turns off
after 8 minutes. To turn on, just begin
to iron again.
30 sec