Setting up Home Connect
You can start the Home Connect assistant to connect to
the Home Connect network and pair your mobile device.
Touch "Home Connect".
1.
Touch "Start assistant".
2.
Follow the instructions in the chapter "Home
3.
Connect".~ "Home Connect" on page 28
Note: You can also activate this feature later in the
"Settings" menu.~ "Adjust Basic Settings" on page 16
Notes
You can change these settings at any time in the basic
▯
settings.
After connecting the appliance to the power or
▯
following a power failure, the settings for initial use are
shown in the display.
Cleaning the Accessories
Clean the accessories thoroughly using soapy water and
a dish cloth or soft brush.
Adjust Basic Settings
You can adjust various settings of your appliance, to
make using your appliance easy and convenient. If
necessary, you can change these settings in the menu
"Settings".
Changing the Settings
Touch the ON l OFF touch button.
1.
Touch the MENU touch button.
2.
Swipe to the left or right to select "Settings
3.
Touch "Continue".
4.
Swipe to the left or right to select the desired setting.
5.
Touch the bottom touch field.
6.
Swipe to the left or right to select the desired setting.
7.
Touch the
icon (where applicable) to apply the
8
8.
setting.
Touch the MENU touch button.
9.
Touch "Save" to save the changes.
10.
16
Available Settings
Setting
Time of day
Language
Clock format
Clock display
Temperature for-
mat
Signal volume
Key press sound On, Off
Display bright-
ness
Standby mode
Start-up anima-
tion
Convection Con-
version
Temperature off-
set
Sabbath mode
Home Connect
".
4
Demo mode
Factory settings
Customer Ser-
vice
--------
Option
Time in hours and minutes
English, Français, Español
12 hr, 24 hr
Digital, Analogue
Fahrenheit (°), Celsius (°C)
1 - 5
1 - 5
On, Off
On, Off
On, Off
Decreases oven temperature by
25° F (4 °C)
Temp offset: Upper
▯
-35°F to +35° F
(-20 °C to +20 °C)
Temp offset: Lower
▯
-35°F to +35° F
(-20 °C to +20 °C)
On, Off
WiFi: On, Off
Remote control: On, Off
Disconnect from network
Connect to app
Show network status
Customer Service access:
Allow (Display shows
▯
Deny
▯
On, Off
Restore
Displays Customer Service contact
information
t
)