Replacing The Refractory Plate; How To Order Replacement Parts - GGM gastro POP434E Mode D'emploi

• Disconnect the supply wires related to the resistors being replaced;
• Move the rock wool to access the anchoring screws of the resistors being replaced;
• Remove the resistors;
• Carry out the operations in reverse to re-assemble.
• To replace the bottom element resistors remove the rear panel;
• Disconnect the supply wires related to the resistors being replaced;
• Move the rock wool to access the anchoring screws of the resistors being replaced;
• Remove the resistors;
• Carry out the operations in reverse to re-assemble.

Replacing the refractory plate

CAUTION!
To carry this operation out it is recommended to remove the bottom element resistors inserted inside refractory
plates (see Replacing bottom element resistors).
Once the "Safety precautions" have been carried out replace the refractory plate as follows:
• Remove the resistors related to the refractory plate being replaced (see resistor Replacement);
• Open the oven chamber door;
• Lift up the refractory plate levering it with a screwdriver;
• Replace the refractory plate;
• Carry out the steps for re-assembling the resistors.

How to order replacement parts

To order replacement parts the following information must be provided, which can be found on the silver label situated on
the right side of the oven:
• Oven model;
• Oven ID (Serial Number);
• Component code (see replacement parts list);
• Quantity required.
75